Instructions / Assembly

Directions:
WARNING: If you scrape, sand or remove old paint, you may release lead
dust. LEAD IS TOXIC. Contact the National Lead Information Hotline at 1-
800-424-LEAD or log on to www.epa.gov/lead.
1. Area must be clean, dry and free from paint, varnish, dirt, and grease. If
working with rotted or soft wood, remove loose material and apply
Minwax®High Performance Wood Hardener to strengthen wood fibers
and to form a solid base for filling.
2. Scoop a golf ball size amount of filler into plastic lid and squeeze in a
thin 3/4 inch long line of hardener from the tube. Mix thoroughly. (Mix
only as much as can be used in 15 minutes.)
3. Apply the mixed paste immediately to the area to be repaired. Spread
on a thin layer followed by sufficient product to fill the gap. Slightly over-
fill to allow for sanding down. Work quickly as the mixture remains
workable for about 10 minutes at room temperature. (To fill deep holes,
spread on 1/8 inch thin layers one at a time until the hole is filled.)
4. After approximately 20 minutes, the repair should be hard enough to be
carved and shaped using a sharp modeling knife.

Summary of content (3 pages)