SAFETY DATA SHEET 385 Section 1. Identification Product name Product code Other means of identification : MINWAX® POLYSHADES® Interior Stain & Polyurethane Satin Finish Mission Oak : 385 : Not available. Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Not applicable.
Section 2. Hazards identification Precautionary statements General Prevention Response Storage Disposal Supplemental label elements Hazards not otherwise classified : Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand. : Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wear protective gloves. Wear eye or face protection.
Section 4. First aid measures Description of necessary first aid measures Eye contact Inhalation Skin contact Ingestion : Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10 minutes. Get medical attention. : Remove victim to fresh air and keep at rest in a position comfortable for breathing.
Section 4. First aid measures Ingestion : Adverse symptoms may include the following: nausea or vomiting reduced fetal weight increase in fetal deaths skeletal malformations Indication of immediate medical attention and special treatment needed, if necessary Notes to physician Specific treatments Protection of first-aiders : Treat symptomatically. Contact poison treatment specialist immediately if large quantities have been ingested or inhaled. : No specific treatment.
Section 6. Accidental release measures Environmental precautions : Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant authorities if the product has caused environmental pollution (sewers, waterways, soil or air). Methods and materials for containment and cleaning up Small spill Large spill : Stop leak if without risk. Move containers from spill area. Use spark-proof tools and explosion-proof equipment.
Section 8. Exposure controls/personal protection Control parameters Occupational exposure limits Ingredient name Exposure limits Mineral Spirits (Odorless) ACGIH TLV (United States, 4/2014). Absorbed through skin. TWA: 200 mg/m³, (as total hydrocarbon vapor) 8 hours. OSHA PEL (United States, 2/2013). TWA: 100 ppm 8 hours. TWA: 400 mg/m³ 8 hours. ACGIH TLV (United States, 4/2014). Absorbed through skin. TWA: 200 mg/m³, (as total hydrocarbon vapor) 8 hours. ACGIH TLV (United States, 4/2014). TWA: 0.
Section 8. Exposure controls/personal protection Other skin protection Respiratory protection : Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. : Use a properly fitted, air-purifying or air-fed respirator complying with an approved standard if a risk assessment indicates this is necessary.
Section 10. Stability and reactivity Hazardous decomposition products : Under normal conditions of storage and use, hazardous decomposition products should not be produced. Section 11. Toxicological information Information on toxicological effects Acute toxicity Product/ingredient name Result Species Cobalt Naphthenate Cobalt 2-Ethylhexanoate LD50 Oral LD50 Dermal LD50 Oral LD50 Oral Rat Rabbit Rat Rat Methyl Ethyl Ketoxime Dose Exposure 3900 mg/kg >5 g/kg 1.
Section 11. Toxicological information Name Category Route of exposure Target organs Mineral Spirits (Odorless) Med. Aliphatic Hydrocarbon Solvent Aliphatic Solvent Category 2 Category 2 Category 2 Not determined Not determined Not determined Not determined Not determined Not determined Aspiration hazard Name Result Med. Aliphatic Hydrocarbon Solvent ASPIRATION HAZARD - Category 1 Information on the likely routes of exposure : Not available.
Potential immediate effects : Not available. Potential delayed effects : Not available. Potential chronic health effects Not available. General Mutagenicity : May cause damage to organs through prolonged or repeated exposure. Once sensitized, a severe allergic reaction may occur when subsequently exposed to very low levels. : Suspected of causing cancer. Risk of cancer depends on duration and level of exposure. : No known significant effects or critical hazards.
Section 13. Disposal considerations when recycling is not feasible. This material and its container must be disposed of in a safe way. Care should be taken when handling emptied containers that have not been cleaned or rinsed out. Empty containers or liners may retain some product residues. Vapor from product residues may create a highly flammable or explosive atmosphere inside the container. Do not cut, weld or grind used containers unless they have been cleaned thoroughly internally.
Section 16. Other information Hazardous Material Information System (U.S.A.) Health * 2 Flammability 2 Physical hazards 0 Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or risks Although HMIS® ratings are not required on SDSs under 29 CFR 1910. 1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program.
