Instructions / Assembly

6. Let dry at least four hours, then sand entire surface lightly with very fine
sandpaper (220 grit) to ensure an even finish and proper adhesion of
additional coats.
7. Apply second coat. If a third coat is desired, repeat Step 6 before
applying. Note: For exterior surfaces or for previously unfinished wood,
three coats are recommended.
8. After final coat, allow 24 hours before normal use.
CLEANUP: For easy clean-up use mineral spirits or paint thinner.
COVERAGE: Approximately 125 sq. ft. per quart
Note: Dry times are based on good ventilation, temperature of 77°F and 50%
relative humidity. Lower temperature, higher humidity, lack of air movement or
application of thick coats will extend drying times. Always test surface for
tackiness between coats. When used for exterior applications, maintain by
lightly sanding and adding an additional coat(s) as conditions require.
NOTE: The product may appear slightly dark or purple in the can, but it dries
clear.
Helmsman® Spar Urethane is not recommended for large exterior surfaces
where maintenance would be difficult, such as decks and siding. Slight
ambering may be experienced when Helmsman® Spar Urethane is applied
over light-colored stains or wood surfaces. Always spot test on a hidden area
to ensure satisfactory results.
DANGER: Rags, steel wool, other waste soaked with this product,
and sanding residue may spontaneously catch fire if improperly
discarded. Immediately place rags, steel wool, other waste soaked
with this product, and sanding residue in a sealed, water-filled
metal container. Dispose of in accordance with local fire regulations.