Instructions / Assembly

4. Apply a thin coat using a lambswool or synthetic pad applicator, or a
natural bristle brush. Maintain a wet edge to avoid lap marks.
5. Let dry at least 3-4 hours until film is no longer tacky to the touch. If
allowed to dry for more than 12 hours, sand lightly with 220 grit
sandpaper, then wipe floor with a cloth moistened with mineral spirits to
remove all dust.
6. Apply a second coat of Minwax® Super Fast-Drying Polyurethane for
Floors following steps 4 and 5.
7. If the floor was not stained, apply a third coat of Minwax® Super Fast-
Drying Polyurethane for Floors following steps 4 and 5.
Floor will accommodate light foot traffic 12-18 hours after the final coat of
Minwax® Super Fast-Drying Polyurethane for Floors. Avoid heavy traffic and
do not replace furniture for 72 hours after the final coat of Minwax® Super
Fast-Drying Polyurethane for Floors. When replacing furniture, do not slide.
Do not install rugs or clean floors for 7 days to allow finish to cure properly. To
clean floors protected by Minwax® Super Fast-Drying Polyurethane for Floors,
we recommend a gentle cleaner such as Minwax® Hardwood Floor Cleaner.
CLEANUP: For easy clean-up, use mineral spirits or paint thinner.
COVERAGE: Approximately 600-700 sq. ft. per gallon
Note: Above dry times are based on good ventilation, temperature of 77°F
and 50% relative humidity. Lower temperature, higher humidity, lack of air
movement or application of thick coats will extend drying times. Always test
surface for tackiness between coats. Do not re-coat when surface is tacky.
Slight ambering may be experienced when polyurethane is applied over light-
colored wood surfaces. Always spot test on an inconspicuous area to ensure
satisfactory results.
NOTE: The product may appear slightly dark or purple in the can, but it dries
clear.
DANGER: Rags, steel wool, other waste soaked with this product,
and sanding residue may spontaneously catch fire if improperly
discarded. Immediately place rags, steel wool, other waste soaked
with this product, and sanding residue in a sealed, water-filled
metal container. Dispose of in accordance with local fire regulations.