User`s manual

SNMP-SSL
6
Chapter 2 Installation
To install SNMP-SSL card on a network you need a workstation running Microsoft
Windows (9x, Me, NT4.0, 2000, XP or later). If your network dynamically configures the IP
address, all you need is a workstation with a Web Browser.
There are three methods for setting the SNMP-SSL card’s configuration:
1. Set up via serial port
2. Set up via Telnet
3. Set up via Web Browser
Hardware Installation
Note: The SNMP-SSL cards are designed to be Hot Swappable, but there is a remote
chance that when Hot-Swapping the SNMP-SSL card that the UPS will shutdown.
MINUTEMAN recommends following steps 1 through 4 when installing the SNMP-SSL
card, but to hot-swap, skip to step number 3.
1. Turn off all the equipment that is plugged into the UPS.
2. Turn off the UPS and unplug the UPS’s power cord from the AC wall outlet.
3. Remove the Option Slot cover plate from the rear panel of the UPS.
4. Insert the SNMP-SSL card into the option slot and secure with the retaining screws.
Figure 2-1: SNMP-SSL card and UPS connection