User`s manual

SNMP-SSL
46
UPS Extended Log Data
This menu gives a consolidated view of the UPS parameters taken over a period. For
each of the UPS parameters, minimum, maximum and the average values are shown in
each of the records. The Administrator can change the time interval in the SNMP-SSL
Configuration page. The existing values are overwritten when the maximum number of
entries (rows) has been reached. The Administrator has the access right to delete the log
file. Note: To Save or Clear the log files go to the Clear & Save Log Data menu.
1. Start Date: Date on which the entry was made.
2. Start Time: The time in a 24-hour format when the values were recorded.
3. End Date: The ending date of the consolidation interval.
4. End Time: The ending time of the consolidation interval.
5. Input Voltage: The minimum, maximum and average values of the input voltage in
Volts.
6. Output Voltage: The minimum, maximum and average values of the output voltage
in Volts.
7. Output Load: The minimum, maximum and average values of the output load
expressed in percentage.
8. Battery Capacity: The minimum, maximum and average values of the battery
capacity expressed in percentage.
9. Input Frequency: The minimum, maximum and average values of the input
frequency in Hertz.
10. UPS Temperature: The minimum, maximum and average values of the UPS’s
internal battery temperature.
11. EMD Temperature: The minimum, maximum and average values of the EMD
temperature.
12. EMD Humidity: The minimum, maximum and average values of the EMD humidity.
Figure 6-2 UPS Extended Log Data