User`s manual

SNMP-SSL
32
Chapter 5 SNMP-SSL Management
The following menus allow the user to configure the SNMP-SSL control parameters. All
the menus are available for all users in the read-only mode, except for the administrator,
which has access in the read/write mode.
Date and Time
This menu allows you to set the SNMP-SSL card internal date and time.
There are three ways to set the Date and Time:
1. Synchronize with computer time
2. Synchronize with NTP server
3. Set the date and time manually
4. Set Value: Saves the settings.
Figure 5-1 Date and Time
SNMP-SSL Configuration
This menu allows the administrator to set the local network configuration parameters for
the SNMP-SSL card. The basic variables for SNMP management can also be set.
1. SNMP-SSL IP Address: The IP address of the SNMP-SSL card (e.g.
192.168.1.100). Note that changing the IP Address of the SNMP-SSL card does not
require rebooting.
2. SNMP-SSL Gateway Address: The IP address of the network gateway (e.g.
192.168.1.254).
3. SNMP-SSL Subnet Mask. The Subnet Mask for your network (e.g. 255.255.255.0).
4. System Name: SNMP Network Administrator string.
5. System Contact: SNMP Network Administrator string.
6. System Location: SNMP Network Administrator string.
7. Last Battery Replacement Date: The date when the UPS’s batteries were last
replaced. Only the Administrator should reset this value.