User`s manual

SNMP

If you are using a Windows 95/98/Me operating system, you can configure the SNMP

parameters directly from the SentryPlus:

Select the Accept SNMP packet from any hosts, SentryPlus will accept all the requested

commands and set commands. When you select the Accept SNMP packet from the

following hosts, SentryPlus receives information only from the hosts that you assigned.

Once a power event has occurred and the user enables the SNMP Trap in the Action

dialog box, SentryPlus will send the SNMP trap to the hosts that are listed in the Trap

Target list box. To add, modify or delete the host, click on its respective command button.

If you are using a Windows NT or Windows 2000 operating system, you must install the

SNMP Service and configure the SNMP parameters from your operating system:

SentryPlus will ignore the values that were set in the SNMP dialog box. To change the

parameters of SNMP function, you should install the SNMP Service in the Network option.

Select the SNMP Service from the Network option in the Control Panel and click the

Property button to do your changes.