User`s manual

31
Wake On LAN
To wake up the remote host, SentryPlus sends notification through the network. You
must provide the IP address and the network hardware address of the remote host. In
Windows98, you can execute the "ipconfig /All" command under the MS-DOS prompt to
obtain the network cards physical address of the local host. Or, input the "arp -a"
command to see the remote host’s physical address. Your network card must support the
remote wakeup feature and this function should be enabled.
a. SentryPlus Resume The Computer From Suspend Mode: SentryPlus will reinstate the
computer into normal mode, and the program will awaken the remote hosts once the
actions have been enabled.
b. Each Time SentryPlus Startup: Program will wake up the remote hosts which are
enabled when SentryPlus starts and is connected to the UPS.