User`s manual

SITE WIRING FAULT
After plugging in the UPS, check the site wiring fault (SWF) LED on the rear of the unit. If the
LED is illuminated, the UPS is plugged into an improperly wired AC outlet.
CHARGING THE BATTERIES
The Smart Up Series UPS’s will charge the batteries whenever the unit is connected to an
AC source. It is recommended that the UPS batteries be charged for a minimum of 4 hours
before use. The UPS may be used immediately. However, the “on battery” run time may be
less than normally expected.
CONNECTING YOUR EQUIPMENT
Plug the equipment into the receptacles on the rear of the unit. Insure that you do not exceed
the maximum output rating of the UPS (refer to the back panel of the UPS or the electrical
specifications in this manual). For non-critical loads, such as printers, it is recommended that
the equipment be connected to the Surge Only outlet.
CAUTION! BE SURE ALL CRITICAL LOADS ARE CONNECTED TO THE
BATTERY SUPPLIED OUTLETS. THE SURGE ONLY OUTLET IS NOT A BAT-
TERY SUPPLIED OUTLET.
CAUTION! DO NOT CONNECT A LASER PRINTER TO THE BATTERY
SUPPLIED RECEPTACLES ON THE UPS. LASER PRINTERS MAY BE
CONNECTED TO THE SURGE ONLY OUTLET.
CAUTION!: IF THE UPS INDICATES A SITE WIRING FAULT, HAVE A
QUALIFIED ELECTRICIAN CORRECT THE PROBLEM.
ON/TEST/SLIENCE SWITCH
Press and release this switch to turn the UPS on. After the UPS is ON, pressing this
switch will implement a self test. When the UPS is in battery mode, pressing this switch
will silence the alarm. If utility line is not present, press and hold this switch for 2 seconds
and the UPS will turn on.
7