User`s manual

BATTERY REPLACEMENT PROCEDURE

PLEASE READ THE PREVIOUS “CAUTIONS” SECTION BEFORE ATTEMPTING

TO REPLACE THE BATTERIES

Battery replacement is a safe procedure when cautions and instructions are carefully

followed. You may leave the UPS and the loads on for the following procedure.

1. Hold the top of the front panel, tilt it out and pull it carefully away from

the chassis.

2. Loosen the bottom of the front panel from the chassis and place it on

the top of the UPS. Be cautious so as not to pull the ribbon cable and

touch the LED printed circuit board.

3. Use a spanner to unlock, remove and open the battery door.

4. Carefully and smoothly pull the battery out of the UPS.

Grasp and tilt out and down

Step 1:

Step 2:

Place the front panel

Step 4:

Pull battery out

Step 3:

Use a spanner to let the

battery door down