Specifications

Parts and Instruction Manual
Page 25
Daily Weekly Monthly Yearly
Charge Batteries Check Each Battery
Cell(s) Water Level
Lubrication –
Grease Fittings,
chains, etc.
Check Carbon
Brushes
Check/Clean Tanks
& Hoses
Inspect Scrub
Housing Skirts
Check/Clean/Rotate
the Brushes/Pads
Inspect and Clean
Solution Filter
Check/Clean the
Squeegee
Check Foot/Parking
Brake for Wear &
Adjustment
Check/Clean
Vacuum Shut-Off
Float
Clean Spray jets on
Cylindrical System
Check/Clean the
Vacuum Motor
Foam Filter
Clean Hopper on
Cylindrical System
Have Minuteman check the vacuum motor carbon motor brushes once a year or
after 300 operating hours. The brush motor carbon brushes should be checked
every 500 hours or once a year.
NOTE: Refer to the Service Manual for more detail on maintenance and service
repairs.
Regularly scheduled lubrication of certain machine parts should be performed to insure
trouble-free operation of the machine. Apply a generous amount of grease into the
fittings on the machine until grease seeps out around the bearings.
The grease points are listed below:
 Rear squeegee caster wheel axle (2)
 Rear squeegee caster wheel stem (2)
 Side squeegee caster wheel axle (2)
 Side squeegee caster wheel stem (2)
 Steering wheel chain sprockets and idlers
Apply lubricant or light machine oil to lubricate the:
 Rear squeegee general pivot points
 Side squeegee general pivot points
 Scrub deck linkages
 Drive wheel assembly seals.
Maintenance Schedule
Lubricating the Machine