Specifications

Parts and Instruction Manual
Page 23
Follow the instructions in preparing the machine for use as described in this
manual.
1. While seated on the machine, adjust the steering wheel to desired position using the tilt
lever.
2. Turn the Key switch ON (I). The Battery Gauge will light up and display the Remaining
Battery Life.
3. Select one of the five available Modes on the Control Console for the required task.
Refer to the Operation Modes section of this manual for a complete description of the
functions.
4. Determine the direction you need to travel by selecting forward or reverse on the
Directional Switch. Vary the pressure exerted on the accelerator pedal to propel the
machine at the desired speed.
5. Stepping on the Accelerator Pedal turns on the Transport, Brushes, Water Flow,
Vacuum and lowers the Rear Squeegee accordingly to the Mode selected. If the
operator steps on the accelerator pedal before, or turns the ke
y
switch “ON” at the same
time, the machine will not move as a safety precaution. Simply remove your foot off the
pedal and step on the pedal again to drive the machine. Please refer to the Main
Operation Modes section of this manual for a complete description of the functions.
6. When Reverse is selected on the Directional Switch, the Rear Squeegee is
automatically raised when you step on the accelerator pedal. However, the scrub
brushes will continue to rotate and solution will continue to flow.
7. Start scrubbing by driving the machine forward in a straight line at ¾ speed and overlap
each pass by 2 to 3 inches. Adjust your speed, brush pressure, and solution flow
according to the condition of the floor.
CAUTION!
To avoid any damage to the floor, keep the machine moving when the brushes
are turned on.
8. When scrubbin
g
, check behind the machine occasionall
y
to see that all the dirt
y
water is
being picked up. If streaking occurs, your Recovery Tank may be full, the Squeegee
hose may be clogged, or the Rear Squeegee may require some adjustment.
9. Make the necessary adjustments on the Rear and Side Squeegees if streaking occurs
both in straight paths and in turns. Pleas refer to the Rear Squeegee and Side
Squeegee section of this manual before making any adjustments.
10. In cases where the floors are extremely soiled and dirty, the Double Scrub mode may
be needed. As described in the Operation Modes section of this manual, this mode
allows the operator to be able to scrub an area without recovering the cleaning solution
with the rear squeegee in the raised position (no vacuum) to allow the cleaning solution
a longer time to loosen dirt. A final pass on the same area is made with the mode
switched over to either Full Function or Vacuum Only mode to recover the dirty water.
11. The recovery tank has a safeguard for overflow protection to guard against water from
entering the vacuum system when the recovery tank is full. The vacuum will stay ON for
15 seconds and then shut-off automatically. A ball float shut-off system has also been
integrated into the Recovery Tank. When the dirty water reaches a certain level, the ball
gets suctioned into the vacuum manifold and blocks the airflow thus, preventing the
machine from picking up more liquid. When this happens, the operator is then required
to stop scrubbing and empty the recovery tank.
Machine Operation