Specifications

Parts and Instruction Manual
Page 22
The SCV Rider
This machine was designed with total operator comfort and ease of use in mind. All
machine components have been designed as a total system to efficiently clean dirty
floors. The SCV has four available scrub head types and sizes to fit specific
applications. Please contact your Minuteman representative for specific
recommendations for the correct scrub head type, size, and brush type and chemical
applications.
Before usin
g
the machine, alwa
y
s perform the followin
g
steps to ensure proper machine
operation.
Check under the machine for leaks.
Check the rear and side squeegees for wear and damage.
Check the steering for proper operation.
Check the solution and recovery tanks.
A
fter using the machine, always perform the following steps:
Check the battery charge level. Charge batteries if necessary. When charging
batteries, extra precaution is required:
Battery acid can cause burns. When working on or around batteries, always
wear protective clothing and safety glasses. Remove metal jewelry. Do not
lay tools or metal objects on top of the batteries.
Charging batteries generate explosive gasses. DO NOT CHARGE
BATTERIES WHEN OPEN FLAMES OR SPARKS ARE PRESENT. DO
NOT SMOKE. Make sure the charger is turned off before disconnecting it
from the batteries. Charge the batteries in a well-ventilated area. Fluid levels
should be checked before and after charging and maintained at the proper
levels. If low, add water until the metal plates are covered. If the machine is
not used for an extended period of time, batteries should be kept fully
charged with a boost charge once a week.
Check for wire, string, or twine wrapped around the scrub brushes.
Check the squeegees for wear and damage.
Check the rear squeegee suction hose and off-aisle wand hose for obstructions.
Empty and clean the debris box (cylindrical systems only).
Drain and clean the recovery tank.
Check under the machine for leaks.
Check the service records to determine maintenance requirements.
WARNING!
Be sure you understand the machine controls and their functions.
While on ramps or inclines, avoid sudden stops when tanks are filled.
Avoid abrupt sharp turns. Slow down driving speed when going downhill.
Always drive up when cleaning ramps.