Specifications

Parts and Instruction Manual
Page 18
The side squeegees (left and right) are attached to the scrub decks. These items
channel the dirty solution to the rear squeegee, helping contain the water within the
machine’s cleaning path. These squeegees are raised when the scrub deck is in the
raised position.
The side squeegees are pre-adjusted at the factory. Adjustments may be
required when replacing worn blades or to achieve optimum performance for
different floors and conditions.
To adjust the side squeegees, simply loosen the mounting hardware (Two wing nuts
for Disk Scrub Deck, two black three-sided knobs for Cylindrical Scrub Deck). Lower
the scrub deck by switching to a scrubbing mode and when the brushes start up,
turn off the key switch. At this point the side squeegees should be resting vertically
(no deflection) on the floor. Press down on the side squeegee bracket assembly
from each end while making sure that the blade is uniformly deflected in a 45 degree
angle along its whole length. Tighten the wing nuts (item A). Turn the steering wheel
all the way to the left or right and start pushing the machine to the side to inspect the
blade deflection and wiping action. Repeat the steps above until a satisfactory result
is obtained.
A
B
C
Wing Nut for Squeegee Adjustment (2)
Helical Lock Washer for Squeegee Adjustment (2)
Flat Washer for Squeegee Adjustment (2)
Side Squeegees
Disc Deck Side Squeegee Components