Specifications

Parts and Instruction Manual
Page 11
The steering wheel is adjustable for
operator comfort by pulling the tilt-
steering lever up and positioning the
steering wheel up or down (there
are three possible positions). Pulling
on the tilt-steering lever and
positioning the steering column in
an upright position provides the
operator with more room when
climbing up and down the machine.
Located on the right side of the operator compartment on the floor is the accelerator
pedal. This pedal controls the propelling speed of the machine. The farther the pedal
is pushed down the faster the machine will travel. As discussed earlier, the
directional switch governs the direction of travel the machine will take. Switching the
directional switch with the pedal depressed will make your machine change
directions (a very slight delay may occur before the direction of travel changes when
switching directions on the fly). The accelerator pedal is interlocked with the seat
switch, making machine propulsion not possible without the operator sitting on the
seat. The accelerator pedal is also linked to the machine’s dynamic braking system.
During operation, when the accelerator pedal is released, the dynamic braking
system will automatically halt the movement of the machine without need for an
additional brake pedal.
The ergonomically designed seat is located on top of the solution tank. There is a
lever under the seat that allows the operator to adjust the seat forward or backward
for operator comfort. There is an interlock switch located inside the seat. This makes
it impossible to engage the traction drive circuitry without the operator on the seat. If
the operator were to fall off the machine, the traction drive circuitry would turn off.
Located on the lower front of the control console, this switch controls the direction in
which the SCV will move when the accelerator pedal is activated. Flipping this
switch to the down position will set the machine to move forward. Flipping it to the up
position sets the machine to move in reverse.
This machine is equipped with an Electro-magnetic brake built-in on the traction
drive motor. When the machine’s power is turned off (using either the key or the
emergency button), the E-mag brake is activated and the traction motor is prevented
from moving.
Operation of Controls
Accelerator Pedal
Seat
Directional Switch
Parking Break
Steering Wheel