Specifications

Parts and Instruction Manual
Page 6
For operator ergonomics, the control console houses all the primary function controls in a
central area. The key switch and optional headlight and off-aisle wand switches are
clustered in the back portion of the console. The directional switch (forward/reverse) is
located at the front of the console for easy fingertip operation. The horn button, function
selectors, and battery gauge are located in the central part of the console.
(A) – Controls the machine’s power (ON/OFF) with a key for safety. All
operational settings are retained even when the power is turned off and on. This also
serves as a reset switch when errors or faults occur.
(OPTIONAL) (B) –
ON/OFF control for the water supply to
the wand and vacuum motor for the optional Off-Aisle Wand.
(OPTIONAL) (C) –
ON/OFF control for the optional headlights.
(D) - Displays the level of charge remaining in the machine’s
batteries. The gauge consists of 10 LEDs. (3 Green, 4 Amber, 3 Red) If the battery life is
low, the battery gauge bar icon will be flashing to inform the operator that the machine is
almost out of power. Once this signal is displayed, all functions will shut off, including
transport mode. The operator must then turn the key switch OFF and then ON to reset
the machine. The machine will then have only a few minutes left of reserve power to
briefly use Vacuum Only mode to pick up any remaining solution on the floor and
Transport mode to return to the charging station. This gauge will also display a fault code
if the system has an error. This code is represented by a specific number of flashing
LEDs. See Fault/Diagnostic Codes for specific code information.
(E) – Adjusts the amount of solution being dispensed to the
floor while in one of the scrub modes. Turn the knob clockwise to increase the amount of
solution being dispensed. The amount of solution applied is variable to a maximum of 1
GPM.
(F) – This knob is used to select the desired operation mode of
the machine. See Operation Modes for information about each mode.
(G) – Depressing
this button will activate the machine’s horn.
(H) –
Flipping this switch to the down position will set the machine
to move forward. Flipping it to the up position sets the machine to move in reverse.
Control Console
Key Switch
Off Aisle Wand Switch
Headlight Switch
Battery Gauge
Solution Control Knob
Mode Selector Knob
Horn Button
Directional Switch