Service manual

6. Table of Error Codes
2C00 LOW BATTERY ERROR Battery Charge to low. Recharge battery.
2C01 LOW BATTERY ERROR2 Battery Charge to low. Recharge battery.
2C02 SOFT BATTERY LOCKOUT OCCURRED Batter Char e to low. Rechar e batter .
yg g y
2C03 SOFT BATTERY LOCKOUT 2 OCCURRED Battery Charge to low. Recharge battery.
2F01 TILLER DISPLACED ERROR Throttle displaced on Power-up. Release throttle and then re-engage throttle.
3A00 BAD SETTINGS Illegal program parameter settings.
7000 STARTUP WITH PUSH SELECTED Freewheel Input signal detected at startup. Disconnect Freewheel input.
7001 PUSH ACTIVATED IN DRIVE MODE Freewheel Input signal activated while driving. Disconnect Freewheel input.
7500
TILLER COMMS TIMEO T
Problem h LCD Module or n Repair or replace as necessary
7500
TILLER
COMMS
TIMEOUT
Problem
with
LCD
Module
or
wiring
.
Repair
or
replace
as
necessary
.
7600 SOFT BRUSH MOTOR DISCONNECTED ERROR Check Brush Motor wiring and connectors
7601 SOFT BRUSH CURRENT FOLDBACK Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7602 SOFT BRUSH CURRENT FOLDBACK2 Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7603 SOFT BRUSH CURRENT FOLDBACK3 Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7604 SOFT BRUSH INHIBIT Brush Inhibit signal is active.
7605 BRUSH STARTUP OVERCURRENT DETECTION Possible Brush motor problem or shorted brush circuit wiring.
7700 SOFT VACUUM MOTOR DISCONNECTED ERROR Check Vacuum Motor wiring and connectors
7701 SOFT VACUUM CURRENT FOLDBACK Too much Vac motor current. Check for shorted Vac motor or wiring.
7702 SOFT VACUUM CURRENT FOLDBACK2 Too much Vac motor current. Check for shorted Vac motor or wiring.
7703 SOFT VACUUM CURRENT FOLDBACK3 Too much Vac motor current. Check for shorted Vac motor or wiring.
7800 TRACTION MOTOR FAULT-1 Check Traction Motor wiring and connectors
7801 TRACTION MOTOR OVER CURRENT ERROR Too much Traction motor current. Check for shorted Traction motor or wiring.
7802 TRACTION MOTOR IN FOLDBACK STATE Traction Motor was overloaded for too long, Control limiting current to protect motor.
7803 MOTOR LINE VOLTAGES INSTABILITY TIMEOUT Possible Traction Motor or loose wiring problem.
7804 TRACTION MOTOR IN DRIVE BOOST Traction Motor under heavy load or Current Limit / Fold back parameters set too low.
7880
TRACTIO SPEED INPUT OUT OF RANGE
Check Throttle
Potentiometer
and
7880
TRACTION
SPEED
INPUT
OUT
OF
RANGE
Check
Throttle
Potentiometer
and
wiring
.
7900 EMERGENCY STOP ERROR Emergency Stop function activated.
7901 SOFT BELLY BUTTON ACTIVATED Safety Bar switch is activated. (ES and CP models only)
8000 SERVICE MODE Service Timer limits have been reached.
9000 BRUSHES NOT FITTED Check Brush Deck to make sure Brushes are fitted properly.
Page 18