Specifications

6 Cylindrical Motor System
7 Disc Motor System
8 Easy On/Off Brushes (cylindrical deck)
The SCV 24/26 cylindrical scrub deck has two 3/4 HP motors to drive the counter rotating
brushes. The scrub deck is equipped with a debris hopper to collect any small debris that
may be on the floor. The brushes counter rotate at 900 RPM with two brush pressure
settings of 80 lbs. for general scrubbing and 160 lbs for heavy-duty scrubbing. The
cylindrical deck has four positive pressure, quick disconnect, spray jets that uniformly
disperse cleaning solution evenly over the total surface of the scrub head.
To remove the two cylindrical brushes, simply pull the cotter retention pin holding the
side wiping skirt and swivel it away from the brush housing. Then remove the three 3/
8" wing nuts that hold the cylindrical brush hubs in place. Once this is done, simply
remove the brush by pulling it out of the brush cavity. The SCV 24/26 cylindrical
brushes are available in seven different grits that will help the customer scrub any
hard surface configuration.
5 Offset Scrub Deck
One of the most unique features on the SCV 24/26 is the offset scrub deck feature. To activate, simply
flip the horizontal switch located at the operator's right knee and the scrub deck will slide to the right,
offset 2", allowing the operator to scrub right up to the base board. Show your customer the value of
this design and how it will benefit them.
The SCV 24/26 scrub deck uses a 1 HP/1.25 HP drive motor respectively. The scrub deck
utilizes a right angle gear box that gives maximum torque to the scrub deck. This scrub
deck offers the operator two pressure settings of 80 lbs. for light scrubbing and 160 lbs.
for heaby-duty scrubbing applications. The disc deck utilizes a positive pressure cleaning
solution injection to the center of the gimble mounted drive hubs.