Owners manual

RPM1521E
27
3-3-5 Syslog
This menu allows the administrator to configure the RPM1521E to send Systems logs.
SYSLOG Test: This is used to verify that the SYSLOG works properly.
Host: The IP address of the Server where the System Logs should be sent.
Port: The port that the Server will use to receive the System Logs. The default port is
514.
ADD: Click the ADD button to add this action.
Save: Once the setup is complete click the Save button to save all of the changes.
3-3-6 Peripheral
This menu allows the administrator to configure the temperature scale for the Device and
the External Temperature Probe.
Temp Scale: Choose either Celsius or Fahrenheit for the Device and External temperature
probe to report.
Released Temp (Range): Once the External temperature drops below the High Alarm
setting by the amount in the Released Temp (Range) the alarm will be cancelled. Once the
External temperature rises above the Low Alarm setting by the amount in the Released
Temp (Range) the warning will be cancelled. This only applies to the External
Temperature Probe.