Owners manual

RPM1521E
26
3-3-4 SNMP
This menu allows the administrator to configure the RPM1521E to send SNMP Traps to
Network Management Stations (NMS).
SNMP v1-v2c Enable: Check the box to enable SNMP v1 & v2c Traps.
SNMP Port: Set the SNMP Access port. The default is 161.
Read Community: A low-level password to restrict SNMP access.
SNMP Writing: Enables the Write Community
Write Community: A high-level password to restrict SNMP access.
SNMP v3 Enable: Check the box to enable SNMP v3 Traps.
Username: Enter the username.
Type: Enter the access type.
Authorization type: Select the authentication type.
Authorization password: Enter the password.
Private type: Select if private type or not private type.
Private password: Enter the password, if required.
SysName: Enter the name of the SNMP device.
SysContact: Enter the name of the System Contact.
SysLocation: Enter the location of the SNMP device.
SNMP Test: This is used to verify that the SNMP Trap notification works properly.
Host: The IP address of the NMS where the SNMP Traps should be sent.
Port: The port that the NMS will use to receive the SNMP Traps. The default value is 162.
Authentication string: Enter the authentication string to access SNMP Trap, if required.
ADD: Click the ADD button to add this action.
Save: Once the setup is complete click the Save button to save all of the changes.