Owners manual

RPM1521E

3-3 System Tab

3-3-1 Network

The RPM1521E can be configured with a Static IP address or setup to use DHCP.

The default setting is DHCP Enabled. If there is no DHCP service then the following

Static addresses are the default settings:

Static IP address: 192.168.1.10

Subnet mask: 255.255.255.0

Gateway address: 192.168.1.1

Ping Test: This will validate the network connection.

Host: Enter the IP address.

Subnet Mask: Enter the Subnet Mask.

Gateway: Enter the Gateway address.

Primary DNS Server: Enter your primary DNS server.

Secondary DNS Server: Enter your secondary DNS server (if required).

HTTP: Enabling or disabling the HTTP connection with the RPM1521E.

HTTPS: Enabling or disabling the HTTPS connection with the RPM1521E.

HTTP Port: The user may change HTTP port to use a port number other than standard

HTTP port (80).

HTTPS Port: The user may change HTTPS port to use a port number other than standard

HTTPS port (443).

Disable ICMP echo (ping) responses: When disabled (checked) the RPM1521E will not

respond to ping request.

Save: Once the setup is complete click the Save button to save all of the changes.