Owners manual

RPM1521E

2-2 Setup-Procedure

The minimum requirement to operate the RPM1521E is to setup the IP Address, subnet

mask, and the gateway. DHCP is enabled as the default. Contact your system

administrator or use the IP Search Utility program (on the CD) to obtain the IP address. If

there is no DHCP server the default settings are as follows:

The default settings are:

IP address: 192.168.1.10

Subnet mask: 255.255.255.0

Gateway address: 192.168.1.1

Account name: admin (lower case)

Password: admin (lower case)

There are two ways to perform the Setup-Procedure:

1. Open a web browser and input either the default IP address or the IP address obtain

from DHCP. Then Setup Wizard will open. Follow the steps to setup the

RPM1521E.

2. Use the IP Search Utility program (on the CD). The IP Search Utility program

supports most Windows Operating Systems.

Setup Procedure using the Setup Wizard

1. Open a Web browser and input the IP address for the RPM1521E.

2. The Setup Wizard will open.

3. Enter the default Account Name (admin). Enter the default Password (admin).

Confirm the Password and then click on the Next button. The Password can be

changed now or later under the Account tab.