User`s manual

iii. When the LED A and H blinking, release the two buttons, the RPM will

respond by sending out 4 short beeps to the caller. The password will be

restored to default.

12. The RPM is in a waiting loop to receive the command string. Each command string

should be entered within 20 seconds. After 180 seconds without any user input,

the RPM will logout the user.

13. The 9 command set is for the administrator:

14. 0190# to turn off all of the outlets.

15. 0191# to turn on all of the outlets.

16. 0192# to reset every port with a delay of 8 minutes, which will allow safe

shutdowns. The delay can be changed by command 888911XXXX#, where XXXX

can range from 1 to 9999 minutes.

17. The user enters 000# that can force to break connection with RPM.

NOTE: When daisy chaining the RPMs and using the telephone to access the

RPMs, the Smart phone card inside all of the RPMs (except the Master RPM) must

be disabled.