Manualshelf

Specifications

ManualsBrandsMinuteman ManualsConsumer electronicsPro 2200r
61626364656667686970
Draper Prison Wasatch & Oquirrh Intercom & Paging System Remodel 4-21-2014
ELECTRICAL CONNECTIONS FOR EQUIPMENT 260070 – 2
C. Power Distribution Blocks: Provide Square D Type LB or Equivalent.
D. Refer to other Division 26, 27, and 28 Sections for specification of electrical materials as
applicable.
PART 3 – EXECUTION
3.1 GENERAL:
A. Make electrical connections in accordance with manufacturer's written instructions, applicable
requirements of NEC, NEMA Standards, and NECA's "Standards of Installation", and in
compliance with recognized industry practices to ensure that products fulfill requirements.
3.2 CONNECTIONS:
A. Permanently Installed Fixed Equipment:
1. Install conductors in flexible conduit from junction box to equipment control
panel or connection point.
2. Where such installations are subject to moisture, install in liquid-tight flexible
conduit.
B. Movable equipment:
1. Provide wiring devices, cord caps, and multi-conductor cables as required.
C. Other methods as required by the NEC and/or as required by special equipment or field
conditions.
D. Power Distribution Blocks: Unless noted otherwise on drawings, provide power distribution
blocks only for tapping of feeders and branch circuits. Locate in junction box or gutter in NEMA
ratings to suit application.
3.3 MANUFACTURER'S INSTRUCTIONS:
A. Obtain manufacturer's instruction and wiring diagram regarding electrical connections of each
piece of equipment and provide connections in accordance therewith.
3.4 VERIFICATION OF LOAD CHARACTERISTICS:
A. Verify electrical load characteristics of all equipment prior to rough-in. Review respective shop
drawings of all other Divisions and Owner's equipment manuals. Report any variances from
electrical characteristics noted in the contract documents to the Architect/Engineer prior to
rough-in.
B. Value of rough-in work, electrical equipment, etc. installed and/or purchased by the contractor
not meeting equipment requirements shall be credited back to the owner.
END OF SECTION 260070
Bid DA14027DFCM
5/30/2014 2:08 PM p. 65