User`s manual

English

7. The UPS system is now ready for the normal start-up procedure (see the

UPS User's Manual). On all the units that were installed, check that all the

switches and all the circuit breakers are in the ON position.

Note: For the installation of multiple Battery Packs see STYLE 7: "Daisy

Chained" Configuration.

STYLE 2: Hardwire Configuration

(Must be performed by Authorized Service Personnel ONLY)

1. Be sure to read the installation placement procedure, caster removal

procedure, the cautions section and the safety precautions section before

installing the Battery Pack(s).

2. Make sure the UPS's power switch is turned off. If the Battery Pack(s) has a

circuit breaker, be sure that the circuit breaker is turned off.

3. Locate the terminal block on the back of the UPS. To properly identify, the

positive connection and the negative connection of the terminal block, refer

to the Installation Section in the UPS's User's Manual.

4. To locate the terminal block on the Battery Pack(s): The terminal block, on

some models of Battery Packs, has an access panel on the rear panel of the

Battery Pack. If the Battery Pack(s) has no access panel, the terminal block

is on the inside of the Battery Pack(s); the top cover will have to be removed.

WARNING: Use extreme CAUTION when the cover of the Battery Pack

is removed. There is a danger of Electrical Shock from the batteries.