User`s manual

English

4. Loosen the retaining screws on the rear panel of the UPS, then slide the

retaining bracket down. The retaining screws do not have to be removed to

slide the bracket down. Not all models have this retaining bracket.

5. Before plugging the connectors together, verify that they mate red to red and

black to black. Plug the Battery Pack's connector into the UPS's external

battery connector.

CAUTION: Use caution when removing the self-stick protective strip from the

UPS's external battery connector and the Battery Pack's connector; the

battery voltage is present at the connector's contacts. If the UPS's battery

connector or the Battery Pack's connector is not being used, the self-stick

protective strip should not be removed.

6. Slide the retaining bracket up to secure the battery connector in place and

tighten the retaining screws. Verify that the bracket will not allow the

connector to be pulled out. NOTE: If the retaining bracket will not slide up,

then the connector is not pushed in all the way.