User`s manual

5
English
INSTALLATION PROCEDURES
MINUTEMAN Battery Packs are available in several different configurations.
Some of the Battery Packs are designed for quick connections and others are
designed for hardwiring by Authorized Service Personnel Only. Follow the
correct procedure for the configuration style that you are installing. Use the
appropriate CAUTIONS for the model being installed. If you are unsure of the
configuration style that you have or have a question about the procedure, please
contact the MINUTEMAN Technical Support Department.
STYLE 1: Plug and Play Configuration
STYLE 2: Hardwire Configuration
STYLE 3: Hardwire & Plug and Play Configuration
STYLE 4: PRO Rackmount Configuration
STYLE 5: Enterprise Universal Series Configuration
STYLE 6: MCP-E Series Configuration
STYLE 7: "Daisy Chained" Configuration
STYLE 1: Plug and Play Configuration
(Must be performed by Authorized Service Personnel ONLY)
1. Be sure to read the installation placement procedure, caster removal
procedure, the cautions section and the safety precautions section before
installing the Battery Pack(s).
2. Make sure the UPS's power switch is turned off. If the Battery Pack(s) has
a circuit breaker, be sure that the circuit breaker is turned off.
3. Remove the self-stick protective strip (not required on all units) from the rear
of the UPS and from the Battery Pack's connector.
NOTE: The red connector is the battery positive (+) and the black connector is
the battery negative (-) on all MINUTEMAN Plug and Play configurations.