User`s manual

English

WARNING! These Battery Packs are extremely heavy. Anytime the Battery

Pack(s) must be handled, be sure to use adequate personnel, strong supports

and equipment to safely handle the Battery Pack(s).

INSTALLATION PLACEMENT

Select the location of the Battery Pack(s) and the UPS using the following precautions:

The Battery Pack(s) and the UPS must be placed on a level smooth surface.

The Battery Packs cannot be stacked more than 4 units high. The Battery

Packs that weigh 80 lbs or more cannot be stacked more than 2 units high.

Install the UPS either on the side of the Battery Pack(s) with enough spacing

for proper air flow or on top of the Battery Pack(s). DO NOT install the Battery

Pack(s) on top of the UPS.

Some of the Battery Packs have casters for mobility. When mobility is not

desired or the Battery Packs are to be stacked, the casters can be removed

and replaced with rubber feet (provided). Follow the instructions below to

remove the casters and install the rubber feet on the XRT Battery Pack(s):

NOTE: A Qualified Technician may need to measure the equipment and the

installation site prior to the installation. Each installation should be planned and

reviewed before installing this heavy equipment into its final location. Verify that

the floor strength is sufficient enough to handle this extremely heavy equipment

prior to the actual installation. Use extreme caution when handling these heavy

Battery Packs.

1. Avoid locations near heating devices.

2. Avoid locations near water or excessive humidity.

3. Do not expose to direct sunlight.

4. Route power cords where they cannot be walked on or damaged.

BATTERY PACK CASTER REMOVAL

(Must be performed by Authorized Service Personnel ONLY)

1. Move the Battery Pack(s) into the area of its final location.

2. Remove the Battery Pack(s) from the wooden skid.

3. With the appropriate support, raise the Battery Pack(s) high enough to

gain access to the bolts securing the casters.

4. Remove the four bolts securing the casters.

5. Install the rubber feet into the holes provided.