User`s manual

English

13. Install the retaining bracket as shown below.

14. Loosen the two cover screws and slide the retaining bracket into place.

15. Retighten the two cover screws.

16. Make sure that, the UPS's and the Battery Pack's circuit breakers are in

OFF position.

17. Make sure that the UPS's power switch is in the OFF position.

18. Make sure that the input circuit breaker (at the breaker panel) is in the

OFF position.

19. Remove the External battery connector's access panel from the back panel

of the UPS and from the back panel of the Battery Pack(s). Use CAUTION

when removing the External battery connector's access panel from the

UPS's and the Battery Pack's back panel; the battery voltage is present at

the External battery connector's contacts. If the UPS's battery connector

or the Battery Pack's connector is not being used, the External battery

connector's access panel should not be removed.

20. Before plugging the battery cable (provided) into the UPS's external battery

connector or the Battery Pack's connector, verify that they mate red to red

and black to black.

21. Connect one end of the Battery Cable to the Battery Pack's connector and

secure by tightening the strain relief screw (do not over tighten).