User`s manual

16
English
6. Verify that all the connections are secure and that the polarity is correct.
7. The UPS system is now ready for the normal start-up procedure (see the
UPS User's Manual). On all the units that were installed check that all the
switches and all the circuit breakers are in the ON position.
Installation of the mounting tray and the stabilizing feet.
The MCP BP5000 and the MCP BP7000 must be installed into a stationary
position due to the hardwiring of the input and the output of the UPS.
Use CAUTION: the Battery Pack(s) and the UPS are extremely heavy.
1. Move the UPS and the battery pack(s) into the desired location.
2. Lay the mounting trays on the floor next to the UPS and the battery pack(s)
as shown.
3. Attach the two mounting trays together.
4. Roll the UPS onto the mounting tray.
5. Roll the battery pack onto the mounting tray.
6. Align the four screw holes on the mounting tray with the four screw holes on
the bracket at the front and rear of the UPS.
7. Install the four mounting tray retaining screws.
8. Align the four screw holes on the mounting tray with the four screw holes on
the bracket at the front and rear of the UPS.
9. Install the four mounting tray retaining screws.
CAUTION: If you reverse steps #4 and #5 or if the Battery Pack's circuit
breaker is in the ON position, the open end of the battery cable will have
battery voltage at the connector's contacts. To avoid this, follow the
procedure in the correct order.