User`s manual

English

6. Make sure that both the Battery Pack's circuit breaker and UPS's power

switch are in off position. Unplug all the equipment that is plugged into the

UPS's output receptacles. Disconnect the power cords that are on the

Battery Pack(s) and the UPS from the AC outlet.

7. Remove the self-stick protective strip from the rear of the UPS and from the

rear of the Battery Pack(s). Use CAUTION when removing the

self-stick protective strip from the UPS's battery connector and the

Battery Pack's connector; the battery voltage is present at the connector's

contacts. If the UPS's battery connector or the Battery Pack's

connector is not being used, the self-stick protective strip should not be

removed.

8. Before plugging the battery cable (provided) into the UPS's external

battery connector or the Battery Pack's connector, verify that they mate red

to red and black to black.

9. Connect one end of the Battery Cable to the Battery Pack's connector and

secure by tightening the thumb bolt screws (do not over tighten).

Connect the other end of the battery cable to the UPS's battery connector and

secure by tightening the thumb bolt screws (do not over tighten).

Once the location and position of the Battery Pack(s)

and the UPS have been determined, lay the Battery

Pack(s) down flat. Align the mounting bracket with

the mounting bracket screw holes and attach with

the retaining screws. Use the template to mark the

bolt hole position on the wall. CAUTION: You should

always were protective gear for your hands and eyes

when operating power tools.

Drill the holes for the

bolts and make sure that all of the holes are drilled

into structural material. Then clean the area of any

loose material. Install the four bolts into the bolt holes.

Do not tighten the bolts all the way, leave

approximately 3/8" of the bolt sticking out. Position

the Battery Pack so that the mounting bracket keyed

holes line up with the four bolts. Slide the Battery

Pack down until its resting securely on the four bolts. Tighten the four bolts

to secure the Battery Pack to the wall. Go to step #6 on page 14 and finish

the rest of this procedure to install the Battery Pack(s).

WARNING: Use two or more people when installing the Wall Mount

Battery Pack(s) and the UPS (see the UPS User's Manual for Wall

Mounting the UPS). Use caution; these units are heavy.

10.

CAUTION: If you reverse steps #9 and #10 or if the Battery Pack's circuit

breaker is in the ON position, the open end of the battery cable will have

battery voltage at the connector's contacts. To avoid this, follow the procedure

in the correct order.