User`s manual

English

Use CAUTION: the Battery Pack(s) are extremely heavy. Once the

location of the Battery Pack(s) and the UPS have been determined, stand

the Battery Pack on its side. Attach the self-stick rubber feet to the bottom

of the Battery Pack, approximately 2" from each corner. Lay the Battery

Pack down on the four rubber feet. Stack the UPS and the monitor on top of

the Battery Pack(s) as shown below.

B. The Tower Configuration allows the user to install the Battery Pack(s)

and the UPS (see the UPS User’s Manual for installation) in the upright

position next to the tower computer. A tower bracket kit is available for both

the Battery Pack(s) and the UPS. Use CAUTION: the Battery Pack(s) and

the UPS are extremely heavy. Once the location of the Battery Pack(s) and

the UPS have been determined, lay the Battery Pack down flat on a desk or

table. Then position the UPS on top of the Battery Pack so that the front

panels are facing in the same direction and the face plates are on the same

end of the units. Position the units so the tower feet brackets will slide on the

units. Locate the mounting screw holes on the side panels of the units. On

each unit there are four mounting screw holes at the front of the unit and four

mounting screw holes at the rear of the unit. Align the tower feet brackets

with the mounting screw holes and attach with the retaining screws. Align

the middle locking brackets with the mounting screw holes and attach with

the retaining screws. This will lock the Battery Pack and the UPS

together. Stand the Battery Pack and the UPS up on the tower feet

brackets. Slide the Battery Pack, the UPS and the tower computer together.

Note: Verify that the Battery Pack and the UPS are stable. The face plates

can be rotated to read in the upright position. To do so, pull the front panels

off the Battery Pack(s) and the UPS. On the backside of the front panel,

locate four tabs holding the face plate to the front panel. Push the four tabs

inward and the face plate will pop out. Position the face plate so that it reads

in the upright position. Reinstall the front panels on the Battery Pack(s) and

the UPS. Go to step #6 on page 14 and finish the rest of this procedure to

install the Battery Pack(s).

NOTE: Do not stack the Battery Pack(s) on top of the UPS or any other

equipment. Go to step #6 on page 14 and finish the rest of this procedure to

install the Battery Pack(s).