Specifications

Unistar Sx Series UPS
Form No. 003-2077
10
CAUTION! DO NOT CONNECT CAUTION! DO NOT CONNECT
CAUTION! DO NOT CONNECT CAUTION! DO NOT CONNECT
CAUTION! DO NOT CONNECT
AA
AA
A
LASER PRINTER T LASER PRINTER T
LASER PRINTER T LASER PRINTER T
LASER PRINTER T
O THE BAO THE BA
O THE BAO THE BA
O THE BA
TTERTTER
TTERTTER
TTER
YY
YY
Y
BACKUP BACKUP
BACKUP BACKUP
BACKUP
RECEPTRECEPT
RECEPTRECEPT
RECEPT
ACLES ON THE UPS UNLESS THE UPS IS RAACLES ON THE UPS UNLESS THE UPS IS RA
ACLES ON THE UPS UNLESS THE UPS IS RAACLES ON THE UPS UNLESS THE UPS IS RA
ACLES ON THE UPS UNLESS THE UPS IS RA
TED 2000VTED 2000V
TED 2000VTED 2000V
TED 2000V
AA
AA
A
OR OR
OR OR
OR
GREAGREA
GREAGREA
GREA
TER. TER.
TER. TER.
TER.
AA
AA
A
LASER PRINTER DRA LASER PRINTER DRA
LASER PRINTER DRA LASER PRINTER DRA
LASER PRINTER DRA
WS SIGNIFICANTLWS SIGNIFICANTL
WS SIGNIFICANTLWS SIGNIFICANTL
WS SIGNIFICANTL
YY
YY
Y
MORE POWER WHEN MORE POWER WHEN
MORE POWER WHEN MORE POWER WHEN
MORE POWER WHEN
PRINTING THAN PRINTING THAN
PRINTING THAN PRINTING THAN
PRINTING THAN
AA
AA
A
T IDLE, T IDLE,
T IDLE, T IDLE,
T IDLE,
AND MAAND MA
AND MAAND MA
AND MA
YY
YY
Y
OVERLOAD THE UPS. OVERLOAD THE UPS.
OVERLOAD THE UPS. OVERLOAD THE UPS.
OVERLOAD THE UPS.
44
44
4
OPERAOPERA
OPERAOPERA
OPERA
TIONTION
TIONTION
TION
TURNING THE UNIT ON/OFF
NOTE:NOTE:
NOTE:NOTE:
NOTE: The UPS is shipped with the unit disabled. Turn dip switch #1 to the ON position before
attempting to turn on the unit. This will enable the unit. Set all of the dip switches per the desired
setting for your environment prior to turning on the unit. Configuration Switches for the SB07001/
2 and SB10001/2. The "System Enable" switch must be enabled for the UPS to operate.
NETWORK SURGE PROTECTION CONNECTION (OPTIONAL)
Connect a 10 Base-T network line to the protection sockets on the rear of the UPS (not available
on all models). This connection will require another length of network cable. The cable coming
from the networked system is connected to the port marked “IN”. The “OUT port is connected to
the equipment to be protected.
NOTE: Connecting to the Network Surge Protection connection is optional. The UPS works
properly without this connection.
CONNECTING YOUR EQUIPMENT
Plug the equipment into the output receptacles on the back panel of the unit. Do not use extension
cords, adapter plugs, power strips or surge strips. The SB50002 and the SB70002 are hardwire
output connections only, be sure the output breaker is in the ON position. Insure that you do not
exceed the maximum output rating of the UPS (refer to the UPS's back panel or the Electrical
Specifications in this manual).
metsyS1WSelbanE=nOelbasiD=ffO
)tratSdloC(qerF2WSzH06=nOzH05=ffO
egatloVtuptuO
tceleS
3WSffOffOnOnO
4WSffOnOffOnO
V001V011V511V021