Installation manual

www.baldormotion.com
A-6 Accessories MN1933
A.1.5 NextMove PC system adapter
The NextMove PC adapter takes the output from the 100-pin connector of NextMove PCI-2
and converts it to be compatible with the NextMove PC cable, allowing for machine conversion
from NextMove PC to NextMove PCI-2 with minimal change to the physical wiring of the
machine.
Catalog
number
Description
OPT026-506 Allows NextMove PCI-2 to connect to a NextMove PC system.
Note: If the NextMove PC breakout module is also being used, the digital input banks
use one common connection. The USR V+ supply is used to determine the sense
of the digital inputs. Connecting CGND to the common connection will cause
inputs to be active high (active when a +24 VDC is applied). Connecting USR V+
to the common connection will cause inputs to be active low (active when a 0V is
applied). Jumpers on the system adapter select whether USR V+ or CGND is
connected to the common connection.
A.1.6 Encoder splitter/buffer board
This is a stand alone PCB that takes an encoder signal, either single ended or differential and
gives differential outputs. This is useful for ‘daisy chaining’ an encoder signal from a master
across a number of controllers. The PCB measures 100 mm x 85 mm (3.94 in x 3.35 in). As
supplied in its TS35 DIN rail mounting PCB holder, the overall dimensions of the unit become
110mmx90mm(4.33inx3.54in).
Catalog
number
Description
OPT029-501
4-way encoder splitter - allows a single-ended or differential encoder pulse
train to be shared between four devices
OPT029-502
8-way encoder splitter - allows a single-ended or differential encoder pulse
train to be shared between eight devices
A.1.7 Spares
These items are located on the breakout module:
Catalog
number
Description
OPT025-501 Cable to allow NextMove PCI-2 to connect to a NextMove PC system.
OPT025-502
Isolated CAN transceiver (SIL hybrid module).
Supports speeds up to 1 Mbit/s.
OPT025-503
Non-isolated CAN transceiver (SIL hybrid module).
Supports speeds up to 500 Kbit/s.