Installation manual

www.baldormotion.com
5-6 Operation MN1933
4. The NextMove PCI-2 will not yet be running any
firmware, so this must now be installed.
Click the Firmware tab at the bottom of the
information pane.
5. In the table, click the most recent build of firmware.
If no firmware is listed, click Install System File...
and locate a suitable .msx file. These are available
on www.baldormotion.com/supportme
.
6. Click Download to Controller.
When the firmware has been downloaded, the
green icon next to ‘NextMovePCI-2 Card 0’ in the
controller pane will turn green.
7. Click the Main tab at the bottom of the information
pane, then click Launch WorkBench.
This will open an instance of Mint WorkBench. The
NextMove PCI-2 will be already connected to the
instance of Mint WorkBench, ready to configure.