Installation manual

www.baldormotion.com
Basic Installation 3-3MN1933
3.2 Installation
NextMove PCI-2 can be installed into an AT style personal computer that has a free 7 inch PCI
card slot. You will need a small cross-head screwdriver to fit the card.
3.2.1 Installing the NextMove PCI-2 card
Before touching the card, be sure to discharge static electricity from your body and
clothing by touching a grounded metal surface. Alternatively, wear an earth strap
while handling the card.
1. Exit any applications that are running and close all windows. Shutdown Windows.
2. T urn off the power (if not automatically done by Windows) and unplug all power cords.
3. Remove the cover from the computer system unit.
4. Locate an unused PCI slot.
5. Remove the backplate cover from the slot, and save the screw for later use.
6. Discharge any static electricity from your body and clothing.
7. Remove the card from its protective wrapper. Do not touch the gold contacts at the bottom
of the card.
8. Align the bottom of the card (gold contacts) with the slot and press the card firmly into the
socket. When correctly installed, the card locks into place.
9. Make sure that the top of the card is level (not slanted) and that the slot on top of the card’s
metal bracket lines up with the screw hole in the PC case.
10. Insert the screw and tighten to secure the card.
If you are also installing an optional NextMove PCI-2 expansion card:
11. Remove the backplate andinstall the NextMove PCI-2 expansion card in the neighboring slot
on the component side of the main NextMove PCI-2 card. See section A.1.1 for details about
connections to the NextMove PCI-2 card.
12. Replace the computer cover and screws.
13. Reconnect any cables and power cords that were disconnected or unplugged.
14. Attach the optional 100-pin cable assembly to the NextMove PCI-2. It is advisable to provide
additional support for the cable to prevent mechanical forces on the connector .
NOTICE