Operation Manual

38
Setting the exposure compensation
To set the exposure compensation, the flash/
display unit must be connected to the camera.
After turning the camera and the flash/display
unit on, push the “down” button until the desired
exposure compensation has been set. The immedi-
ate effect can be seen directly in the display. The
values begin at -0.3 and are settable in increments
of 1/3 EV steps of up to +0.3, which can be seen
in the upper left corner of the display.
Please note:
Only the “down” button can be used to set the
exposure compensation. Please turn the camera
off before removing the flash/display unit to save
your setting. If the flash/display unit is removed
before the camera is switched off, your setting
will be deleted.”
Technical data Flash Unit
Voltage supply to the Flash Unit 4V
Flash Display Current drain (mA)
Off On 140
Charging On 450
Charging Off 310
Measurement is made by using a Flash Unit with
a Spycam.
Selecting the menu language
The MINOX DSC menu items can be displayed
in several languages. If, after switching on the
camera and the flash module, the menus are not
shown in your language, go to the section Adjust-
ing your camera settings > Selecting the language