User Guide

EN-62
Changing the Camera Start Logo Image
You can specify the start logo image for your camera. You can select the new start logo image among
the captured still images.
1. Slide the mode switch to [ ].
2. Select the image that you want to protect with the W / X buttons.
3. Press the MENU button.
J The playback menu is displayed.
4. Select [Setup1] with the X button.
5. Select [Start Logo] with the S / T buttons, and press the SET button.
6. Select [User Image] with the S / T buttons, and press the SET button.
7. Select [Execute] with the S / T buttons, and press the SET button.
J This new start logo image will be activated on the next time you turn on the camera.
J User selected image is saved in the special area of the internal memory. In case of formatting the
internal memory, the user selected start logo image will not be lost.
J “NO IMAGE” message is displayed when “User Image” is selected and no images are
stored in the SD memory card or internal memory.
J If the image recorded voice memo is selected to be the start logo image, the voice memo function
will fail.
J The capacity for saving user image is only one. The previous start logo image will not be recovered
if you select another one as a new start logo image.
2