User's Manual

General instructions

Preparing your binoculars

The scope of delivery of your MINOX BN 7x50 C II DSV

includes a neoprene neck strap. We recommend that

you wear the neck strap whenever you are using your

MINOX binoculars.

Note: By wearing the strap you can avoid damage

caused by dropping the binoculars.

Attaching the neck strap

Thread the strap through the bracket (3) on the body

of the binoculars. Pull the end of the strap back to the

buckle and then thread it through the buckle from be-

hind to secure the strap. Fasten the neck strap on the

other side of the binoculars in the same way. Adjust

the neck strap to a comfortable length once you have

fastened it on both sides.

Attaching the eyepiece cap

Connect the eyepiece cap (11) to the neck strap via the

loop (12) on the left side. The eyepiece cap protects

the optics on the eyepieces against foreign particles,

rain, dust and sand. Remove the eyepiece cap from

the eyepiece when you want to use your binoculars.

This cap then hangs down out of the way on the left

side of the strap.

Objective lens cap

Use the objective lens cap (13) to protect the objective

lenses of the BN 7x50 C II DSV against foreign particles,

rain, salt water, dust and sand. You can attach this

lens cap to your binoculars by placing the loop on the

objective lens cap bracket (14) over the cap screw of

the tripod thread (7) and threading it through until the

loop is completely inserted behind the tripod thread.

Remove the lens cap from the objective lens when

you want to use your binoculars and let it hang down.

If you want to remove the lens cap from your

BN 7x50 C II DSV completely, pull the loop of the

lens cap bracket carefully out from behind the tripod

thread and pull the loop off the cap screw of the tri-

pod thread (7).