User Guide

VERGO is already assembled so you don’t need
to disassemble the kit. You may want to add
or replace optional Fork Mounts. To do so,
follow the steps.
Knob Bolt
Fork Mount
Guide Plate
Base Frame
Base Plate
End Cover
Screw & Washer
Rail
1.
Remove the two screws under the End
Cover with a phillips screwdriver, then the
End Cover will be removed.
2.
Disassemble the Fork Mount. It’s simple,
just remove the knob bolt.
Insert the Base Plate into the Base Frame.
Be sure the direction of the Base Plate must be “M” style, not “W” style.
Place the Guide Plate onto the Base Frame and confirm both adjustment position guides
on the back side are properly fitted to the Rail. The guide will be flush with the base frame.
Place the Fork Mount on the Guide Plate then tighten the Knob Bolt.
3.
4.
5.
6.
Finally, insert the End Cover to the Base Frame and tighten the screws.
OPTION
The “DH Fork Mount” for 20mm axle is available as an option.
DH Fork Mount
for 20mm axle
More Information
Contact: MINOURA JAPAN HEAD OFFICE
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone [phone] / Fax [phone]
Email : [e-mail] / http://www.minoura.jp
MINOURA NORTH AMERICAN CENTER
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Phone [phone] / Fax [phone]
Email : [e-mail]
MADE IN JAPAN
How To Disassemble and Assemble