RS-1100 Bike Fellow 2 Repair Stand INSTRUCTION MANUAL Thank you for purchasing the Minoura RS-1100 repair stand. This foldable, light weight multi purpose stand allows you to use it as both a repair stand and a display stand. A convenient Carrying Bag with a tool pocket is available as an option.
HOW TO ASSEMBLE ¶ No tools are required to assemble your RS-1100. Loosen Knob Bolt-A on Lower Frame, slide up Upper Frame, and tighten again Knob Bolt-A slightly (see Fig. 1) . (Fig. 1) ! ! (Fig. 2) Open Leg-A fully until the leg locks (clicks) in place. When you hear the click sound, Leg-A is locked automatically. After that, open Leg-B fully, then place this stand on the floor (see Fig. 2) . ! (Fig. 3) ! (Fig.
Turn both Arm and Seat Tube Stay fully. Insert Seat Tube Support Bracket through and into the Seat Tube Stay, and insert the plastic cap. (see Fig. 5) (Fig. 5) The BB Support Bracket will help your bike stable during on this stand. The BB Support Bracket will open automatically when you open Arm. (see Fig. 6) (Fig. 6) If you don’t wish to use BB Support Bracket or if you wish to fold this stand, push the Lock Button on the bottom of the Arm. The BB Support Bracket may then folded up or down. (see Fig.
USE RS-1100 AS A REPAIR STAND Place RS-1100 on a flat stable surface. Pull up the Arm Stopper and insert it into the angled hollow firmly to lock it (see Fig. 9) . Arm Stopper ! (Fig. 9) To begin set the left side crank arm downward or a little forward, then twist your bike about 20 degrees counter-clockwise and lift it up. (see Fig. 10) (Fig. 10) ! (Fig. 11) Place the down tube onto both Down Tube Supporters gently. (see Fig. 12) ! (Fig.
Then support the seat tube with Seat Tube Support Bracket. Adjust the position of the bracket not to pinch the cable. The bike is supported safely . (see Fig. 13) Adjust the angle of Arm with Knob Bolt-B in order to fit all contact points to the bike. Make sure all contact points are supporting the bike properly. (see Fig. 14) Finally, sandwich the front wheel with both Front Tire Supporters. This device will make your bike stable and help your work securely while the bike is on this stand. (see Fig.
Place the top tube down softly on both Down Tube Supporter. (see Fig. 17) ! (Fig. 17) FOR WARRANTY, MORE INFORMATION CONTACT : MINOURA WARRANTY CENTER 1415 San Mateo Avenue, South San Francisco, CA 94080 U.S.A. Toll Free: 800-601-9592 MINOURA NORTH AMERICA 37653 B Argyle Rd. Fremont, CA 94536 U.S.A. Phone: 1-510-739-1395 Fax: 1-510-790-1108 E-mail: MinouraUSA@IBM.net MINOURA JAPAN 1197-1 Godo, Anpachi Gifu 503-2305 JAPAN Phone: 81-584-27-3131 Fax: 81-584-27-4258 E-mail: Minoura@Minoura.co.
