User Guide

- 3 -
1
(Fig. A)
2
Mag unit installation
slot
Hub-clamp handle
Mag Unit
Rubber Foot Cap
Remote Control
Lever
Drive roller
Couplings
U-Leg
Frame
Assistant roller unit
installation slot
Drive-pulley lever
Mag Unit Height
Adjust Knob
(Fig. B)
ASSEMBLING YOUR MINOURA TRAINER
Prior to assembly of the Magturbo unit, locate the
two bolts and two washers. Locate the left-side slot
on the Minoura trainer. While placing the Magturbo
unit at the desired position on the inside of the slot,
attach it with bolts and washers by using the included
hex wrench. (see Fig. B)
After installing the Magturbo unit, put the Height
Adjust Knob (maybe an option) through the hole on
the pre-installed bracket on the left side slot, and then
tighten it to the thread on the Magturbo support base.
This optional Height Adjust Knob will help your
adjustment of Magturbo’s height in order to fit the
rubber roller properly to the rim side wall. (see Fig.C)
Open the frame and U-Leg and place on level floor.
(Fig. C)