User Guide

- 8 -
Step 2:
There are four holes and three pins on the Mo-
tor Drive Unit. You can see the position where
a pin is missing. It is the postion where the
Motor Drive Unit must meet the wider span
of the Inner Housing of the Mag resistance
unit.
(see Fig. F)
(Fig. F)
No Pin
Area
Step 3:
Hold the Motor Drive Unit in your hand and place it its Inner Housing in the correct
direction. You will know it is the correct direction because the magnets will repel
against each other. Once this step is achieved, go immediately to Step 6.
CAUTION:
Installation of the Motor Drive Unit in the
WRONG direction will cause the unit to
malfunction and not work. You must
follow all directions and pictures
precisely!!
6.
Secure the Motor Drive Unit with four M3.5x40 self-tap-
ing screws to the Inner Housing. (see Fig. G)
M3.5x40
(or M3.5x35)
Screw
(Fig. G)
Motor Drive Unit
Inner Housing
Motor Drive Unit
CAUTION:
If you install ICE on the Mag unit which
original color of the outer cover is not gray
or yellow, but red, you must use the
shorter (M3.5x35) taping screws because
the depth of the screw holes on older
Inner Housing is too short for screw.