User manual

Visible in finder : step less speeds indicated by 10 light-emitting diodes ;.
LED over-lunder-range indicators; LED at "60" position also blinks as
flash-ready signal with Auto Electroflash 200X and 132X ; f-number set for
automatic and manual modes
Flash sync.:
PC terminal and hot shoe for X sync. (disconnected when unit no installed):
Electronic flash synchronizes at 1/60 sec . and slower step or stepless
speeds; Class
MF, M and FP flashbulbs synchronize at 1/15 or slower
speeds.
Extra contact on hot shoe receives signal from camera-control
contact of Auto Electroflash 200X and 132X
Film advance: Motorized : Through built -in coupler key with accessory Auto Winder G
Manual:
By lever with single 130
0
stroke after 30
0
unengaged movement
Film-advance release button for rewinding; advancing-type frame counter
and Safe Load Signal that indicates film loading and advancing conditions
Power: Two 1.5v silver-oxide cells contained in camera base power both auto
exposure control and shutter's electronically governed operation
LED battery check indicator lights when operating switch in battery check
position
Shutter will not release when voltage too low for proper operation
Self-timer : Electronic, LED indicated types; approximately 10 sec . delay
Other: 4-slot take-up spool; detachable back cover with memo holder and
ASA - DIN conversion scale
Size and
weight : 52 x 88 x 138mm (2 x 3- 7/16 x 5-5/8 in.)
500g
(17-5/8 oz.) without lens and power cells
Accessories: Exclusive
Auto Winder G, Auto Electroflash 200X and 132X, Data Back G,
Remote Cord S 50cm (2Q-in.) and Remote Cord L 5m (16-ft.); MD, Me,
and other interchangeable Minolta lenses ·and applicable Minolta SLR
system accessories
51