User`s guide

Scanning With the Machine
137
" To search registered names, select NAME. To search e-mail
addresses, select E-MAIL.
4 Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the Select key.
The search begins, and the search results appear after a while. If no data
matches the search keyword,
NOT FOUND appears for about two sec-
onds.
" For details on entering/editing text, refer to “Entering Text” on page
265.
" Text starting with the first character of the maximum 10 characters
is searched for. Text will not be found if the search keyword is in
the middle of a word.
5 Press the + or , key to select the desired data, and then press the Select
key.
" To check the found information, press the ) key.
" An e-mail address exceeding 64 characters cannot be specified. If
such an e-mail address is specified, ADDRESS IS TOO LONG
appears for about two seconds, and then the screen for specifying
the destination address appears.
6 Press the Select key again.
7 Press the + or , key to select FINISH, and then press the Select key.
" To add an additional e-mail address, select ADD in step 7, and
then specify the destination.
To delete a specified e-mail address, select
CHECK/EDIT in step
7, and then continue with step 2 of "Deleting a Specified Destina-
tion Address". The address cannot be edited.
Specifying Multiple Destination Addresses
A destination address can be added if a destination e-mail address is speci-
fied.
" If an FTP address or an SMB address was selected, multiple destina-
tion addresses cannot be specified.
1 In the main screen, press the + or , key to select the current data desti-
nation setting, and then press the Select key.
2 Press the + or , key to select ADD, and then press the Select key.
3 Specify the destination address.