User`s guide

ManualsBrandsMinolta ManualsComputer equipmentSCANNER RX-1 - V2.1.0

141

142

143

144

145

146

147

148

149

150

Scanning With the Machine134

3 Press the Select key again.

If an FTP address or an SMB address was selected, the destination

address is specified.

4 If an e-mail address was selected, press the + or , key to select FIN-

ISH

, and then press the Select key.

" To add an additional e-mail address, select ADD in step 4, and

then specify the destination. When sending the data to an FTP

address or SMB address, multiple addresses cannot be specified.

To edit the specified e-mail address, select

CHECK/EDIT in step

4, and then continue with step 2 of "Editing a Specified Destination

Address". To delete an address, select CHECK/EDIT in step 4,

and then continue with step 2 of "Deleting a Specified Destination

Address".

Selecting a Group Dial Destination

A maximum of 20 group dial destinations can be registered on this machine.

(A maximum of 50 e-mail addresses can be registered with one group.) Fol-

low the procedure described below to specify e-mail addresses from the reg-

istered group dial destinations as the recipient of the scan data.

" For details on registering e-mail addresses as group dial destinations,

refer to “Registering Group Dial Destinations” on page 144.

" A group dial destination containing a telephone number cannot be

used in Scan mode.

1 With the main screen or Can Use AddressBook displayed, press the

AddressBook key three times so that Group DIAL appears.

2 Use the keypad to type in the number (between 1 and 20) for the group

dial destination, and then press the Select key.

The information registered for the group dial destination appears for two

seconds.

3 Press the Select key again.

4 Press the + or , key to select FINISH, and then press the Select key.

" To add an additional e-mail address, select ADD in step 4, and

then specify the destination.

To edit the specified e-mail address, select

CHECK/EDIT in step

4, and then continue with step 2 of "Editing a Specified Destination

Address". To delete an address, select

CHECK/EDIT in step 4,

and then continue with step 2 of "Deleting a Specified Destination

Address".