User`s guide

bizhub 215 5-2
5.1 Basic transmission method
5
5 How to Use Scan to E-mail
This chapter describes how to transmit scanned data.
Tips
- To use the Scan to E-mail function, Network Card NC-504 or Image Controller IC-209 and Extended
Operation Panel MK-733 must be installed.
5.1 Basic transmission method
Tips
- With Scan to E-mail, documents are transmitted via mail server. No direct communication with the des-
tination is made. Also, transmission will be handled as completed when communication with the server
ends normally. To carry out this operation, an IP address, SMTP server address, E-mail address, etc.
has to be set in advance.
5.1.1 When using the ADF
1 Press the Scan key.
The machine switches to the scan mode.
2 Load the original onto the ADF.
% The maximum number of originals that can be placed at one time into the ADF is 70. Do not set orig-
inals above the , mark.
% For details on how to set the original, refer to [User's Guide Copy Operations].
% For details on how to set a double-sided original, refer to page 5-3.