Operation Manual

3. Place the colour correction you want to apply

to your image within the the cursor, then click

the mouse button.

• The pointer will move to the new position on the colour map.

• The RGB correction values are displayed to the right of the colour

picker.

Dimâge Scan Dual

2. Click on the appropriate window or

move the sliders to increase or

decrease the contrast and/or

brightness.

• The changes are automatically applied to the preview

image.

• Additional contrast and brightness simulations will be

mapped around the center image.

IMAGE CORRECTION – VARIATION

Adjusting the Brightness and Contrast

Adjusting the Colour

The colour picker consists of a colour map and a pointer. Adjust the colour of your image +/–

20 points in any direction by clicking on any colour tone within the colour map. Colour

corrections at the edge of the colour map are more saturated (stronger). Colour corrections

closer to the center are less saturated. Colour corrections are automatically applied to all of the

image simulations.

The image simulation windows map contrast and brightness changes to the preview image.

The windows display a one step change in the brightness and contrast, but up to 10 steps (+/-)

can be applied. The current colour, brightness, and contrast changes are automatically applied

to the preview image

4. Click on to apply the changes to your scan.

• Click on to cancel all corrections and start over.

• Click on to close the variations window without applying any

corrections.

Cursor

Pointer

Correcting the

brightness and

contrast may

eliminate the need for

colour corrections.