Operation Manual

10
INSTALLING THE SOFTWARE
1. Turn on the Dimâge Scan Dual, then turn on
your PC.
2. Start Windows.
Dimâge Scan Dual for Windows Setup installs the Twain and Twain_32 driver software into the
drive and folder you select.
Photoshop, PhotoDeluxe, Corel DRAW, or Corel PhotoPaint should be installed before you
launch this installer.
• The appearance and/or wording of some dialog boxes may vary depending on the version of Windows running on
your machine.
• The install instructions assume drive D is the CD ROM drive.
• The Device Wizard dialog box will appear.
This step varies with your specific operating software...
Windows 95
Windows 95 Release 2 (OSR2)
and Windows 98
• The New Hardware Found dialog box will appear.
3. Click on Cancel.
• This dialog box may appear several times.
Repeat step 3 until the dialog box no longer
appears.
3. Click on Next until the Unknown
Device window appears…
then click on Finish.
• This dialog box may appear several times.
Repeat step 3 until the dialog box no longer
appears.
Windows NT
3. Select Start > Settings > Control Panel, then double-click on the SCSI
Adapters icon. Confirm that Minolta #2882 appears as a connected
device for your SCSI board.
• If Minolta #2884 does not appear, turn the system off and check all the connections. Repeat the
procedure.